Step 1: Plug in device

Each Penton Pro controller comes with a power cable that plugs into the back of the device.

Step 2: Plug in applicators

Then plug in your desired applicators (the full-body mat or harmony pad) into the round slots on the back of the device, ensuring the pins line up.

Step 3: Switch on device

Once complete, you can then turn the device on via the switch at the back of the device. When pushed towards "O," the device is off. When pushed towards "I," the device will turn on.

Step 4: Setting your frequency

With the arrow buttons found under the left-hand side screen on the device, you can change the frequency within a range of 1-50 Hz.

Step 5: Alter the duty cycle

With the arrow buttons found under the right-hand side screen on the device, you can change the duty cycle.

Step 6: Start program

Once you have entered your desired frequency range and duty cycle, you can click start, and the Penton will begin to emit a magnetic field.

Step 7: Natural progessive mode

If you want to use natural progressive mode, follow steps 1-3, then simply click "natural progressive mode," and the program will begin. The device will emit a field for 20 minutes, and it will rest for 20 minutes. While in each 20-minute segment, the Hz will change.

Step 8: Stop device

If you need to stop the device in either mode for any reason, just click stop, and the device will stop emitting a field.

Step 9: Turn off device

To turn the device off, make sure the program is not running, and then you can simply flip the switch on the back of the device so the switch is towards "O." Then you may unplug your applicators and power cable.